Bernina Bernette 12 Bedienerhandbuch PDF herunterladen (Seite 17)

The thread cutter serves two purposes.

1. Cut the thread after threading the needle

2. Cut the thread after finishing a seam.

To cut the thread after completing your work

raise the presser foot.

Remove the fabric, draw the threads to the

left side of the face cover and cut using the

thread cutter.

The threads are cut at the proper length to

start the next seam.

Thread Cutter

Change the needle regularly, especially if it

is showing signs of wear and causing

problems.

Insert the needle following the illustrated

instructions.

A. Loosen the needle clamp screw and

tighten again after inserting the new

needle. The flat side of the shaft should

be towards the back.

B. Insert the needle as far up as it will go.

Needles must be in perfect condition.

Problems can occur with:

- Bent needles

- Blunt needles

- Damaged points

Attention:

Turn power switch to off ("O") when carrying

out the below operation!

Replacing the Needle

Machine Setup

502020.75.28_021H2D0101_1010_IM_bernette 20 25_EN

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Keine Kommentare

Bernina Bernette 12 Bedienerhandbuch Seite 17